Filter
Top Products
3 Operation
9
E
(3) Operator Attention light (lower light)
This light lights up in yellow when there are errors.
• Lights up in yellow when a hardware error occurs.
• Flashes in yellow when a user-recoverable error occurs.
– The heads need cleaning.
– The tape is nearing the end of its useful life.
– There is a tape in the autoloader, but no magazine is installed.
– The front panel door is open.
Read the message on the top line of the LCD panel and refer to “LCD Messages” in
the Appendix to take any possible corrective action. If following the instructions
given fail to correct the error, call for service.
3.2.2 Front Panel Buttons
(1) Select button
The Select button allows you to select any of the cartridges in the magazine after
the magazine has been loaded into the Unit. If you press the Select button repeat-
edly, the display cycles through the cartridges available in the magazine.
(2) Load Tape button
Use the Load Tape button to load the selected cartridge from the magazine into
the drive.
(3) Eject button
The Eject Button starts the unload process. The drive unloads any currently
loaded cartridge, and the changer mechanism returns the cartridge to the maga-
zine. The magazine is then ejected. The Eject button can also be used to force
ejection in an emergency. See “4.4 Forced Ejection of a Magazine or a Car-
tridge” for details.