Filter
Top Products
12
NOTE:
• Magazine labels must be firmly stuck to the recessed label area on the
side of the magazine and nowhere else. Fixing labels anywhere else
may lead to jams (see figure 4-1). Make sure that labels are firmly
stuck to the surface and not peeling off or curling at the corners.
• Stick only one label on the specified location on cartridges. Do not use
labels that are not supplied with the cartridges and never fix them on
any location other than that specified.
1) Load the required number of cartridges into the magazine by inserting the car-
tridges towards the center of the magazine (see figure 4-1). You can use any
number cartridge from 1 to 6, and place the cartridges in any of the slots on the
magazine.
2) To install the magazine into the autoloader, insert it into the slot in the front of
the autoloader. Make sure that the arrow on the top of the magazine is pointing
towards the autoloader (see figure 4-1). Apply steady pressure until the mecha-
nism takes the magazine and pulls it into the autoloader.
Figure 4-1 Magazine and cartridge set
Loading cartridges into
the magazine
Do not fix labels here
Inserting the magazine into the autoloader