Furuno RP-25 VCR User Manual


 
2. VIDEO PLOTTER
2-24
2.8.4 Setting up the navigation lines
Navigation lines can be set up as follows:
1. Press the [NAV MENU], [3] key to show NAV LINE menu.
2. Press the [7] key several times to select VIDEO PLOTTER at NAV LINE
DATA (item 7) field.
3. Press the [ENTER] key.
[NAV LINE]
1 [VIDEO PLOTTER 1]
2 NAV LINE
3
4 NAV WIDTH
OFF/ON 0.00NM
5 WPT NO.
OFF/ON
6 WPT
(**)->@->(**)
(**)->(**)
7 NAV LINE DATA
VIEO PLOTTER/NAVIGATION
8 ARRIVAL ALARM
OFF/ON 0.00 NM
9 TURNING LINE
OFF/ON REVISED
Nav line menu (Video plotter mode)
4. Press the [4] key several times to select ON at NAV WIDTH (item 4) field.
5. Press the [ENTER] key.
6. Press the numeric key to enter the width for navigation line.
Dashed lines appears at both sides of the navigation line. If unnecessary, select
OFF at step 4.
7. Press the [ENTER] key.
8. Press the [5] key several times to select ON at WPT NO. (item 5) field.
Waypoint No. and marks appears on the navigation line.
9. Press the [ENTER] key.
10. Press the [6] key and then enter the waypoint number in the following case;
·Enter the number of which you are going to the waypoint
·Skip the waypoint which you are going to, and set the next waypoint as
destination