Filter
Top Products
15
Adding a Key Macro:
1. From ADVANCED FUNCTIONS, use the ARROW keys to scroll to
KEY MACRO. Press OK.
2. The remote displays ADD KEY MACRO. Press OK.
3. The remote displays SELECT MACRO KEY. Select any key but
Set, Z-Wave, OK or Arrows (scroll left & scroll right) to store
your macro.
4. The remote displays ENTER THE MACRO SEQUENCE with the
active device highlighted in the bottom line. Use the ARROW
keys to highlight the device for each command.
5. Press the command key that you want to add to the macro.
Note: As soon as you press the first command key, the display
changes to PUSH OK FOR 3 SECONDS TO SAVE. Do not press OK
until you have finished entering all macro commands!
6. To add Z-Wave commands to your macro, press & release the
Z-Wave key to change the remote to Z-wave mode. A small “Z”
will be shown in the upper left corner of the display. Press the
desired light, group or scene mode key, the desired number
key and the On or Off (CH+ / CH-) key to add this command to
the macro. Note: The display does not change to Z-Wave mode
while doing this.
7. Press and release the Z-Wave key to return to A/V mode and
finish programming your macro.
8. When you are finished entering commands for the macro,
press and hold the OK key for three seconds to save your
macro. The remote displays MACRO SAVED and returns to the
KEY MACRO screen.
NOTE: Macros can include up to 30 commands. If you try to
enter more than 30 keys into the macro, the remote displays
MEMORY FULL.
Deleting a Key Macro
1. From ADVANCED FUNCTIONS scroll to KEY MACRO. Press OK.
2. The remote displays ADD KEY MACRO. Scroll to DELETE
MACRO. Press OK.
Advanced Functions
Key Macro
Add Key Macro Delete Macro