Filter
Top Products
7
4. When in setup mode:
• Press and release the SET key to back up one level in
the menu.
• Press and hold the SET key to exit setup mode.
Initial Setup (Audio/Video Devices)
Note: Most devices can be added by entering its code or searching
for its code as described in the following two sections. (Be sure the
device you wish to add is turned on before adding or searching for
its code.) You also have the option of using your device’s original
remote to teach commands to this remote. This is covered in the
“Advanced Functions” section under the “Learn Function” heading.
Adding a Device by Entering Its Code
You can add a device by manually entering its manufacturer’s
code. See “Manufacturer’s Codes” on page 45.
1. Press and hold SET until the remote displays INITIAL SETUP.
2. Press OK. The remote displays ADD DEVICE. Press OK.
3. The bottom line of the display lists RECEIVER as the first device
you can add. Press OK or use the ARROW keys to scroll to a
different device to add and then press OK.
4. Enter the four-digit code for your device. The LED blinks once
for each digit entry. It blinks twice after you have entered the
final digit.
With the remote in A/V mode, press & hold the SET Key
for the following menu options
Initial Setup
Advanced
Functions
About
Z-Wave
Setup
Initial Setup
Add
Device
Change
Device
Code
View
Code
Delete
Device
Replace
Device