Filter
Top Products
Grandstream Networks, Inc. HT-386 User Manual Page 19 of 34
Firmware 1.0.3.64 Last Updated: 2/2007
The password is case sensitive with maximum length of 25 characters. The factory default password for
End User and administrator is “123” and “admin” respectively. Only administrator can get access to the
“ADVANCED SETTING” configuration page.
NOTE:
1. If you CAN NOT log into the configuration page by using default password, please check with the
VoIP service provider. Most likely the VoIP service provider has provisioned the device and
configured for you therefore the password has already been changed.
After a correct password is entered in the login screen, the embedded Web server inside the HT-386 will
respond with the Configuration pages which are explained in details below.
TABLE 7: HT-386 DEVICE STATUS PAGE DEFINITIONS
MAC Address
The device ID, in HEX format. This is very important ID for ISP
troubleshooting.
IP Address
This field shows IP address of the HT-386.
Product Model
This field contains the product model info, such as HT-386.
Software Version
Program: This is the main software release. This number is always used for
firmware upgrade. Current release is 1.0.3.64
Bootloader: current version is 1.1.0.1.
HTML: current version 1.0.3.64.
VOC: current version is 1.0.0.13
System Uptime
This shows system up time since last reboot.
Registered
Whether the unit is registered to service provider’s server.
PPPoE Link Up
This shows whether the PPPoE is up if connected to DSL modem
NAT
This shows what kind NAT the HT-386 is connected to. It is based on STUN
protocol. If the detected NAT is symmetric NAT, STUN will not work and
Outbound Proxy needed to make HT-386 functioning correctly.