Filter
Top Products
ENGLISH
68
SPECIAL SETTINGS
----------------------------------------------------------------------------------------------------------
Searching for digital television
channels from a satellite auto-
matically
Satellite data changes frequently, new chan-
nels are constantly being added. You should
therefore perform an automatic search from time
to time.
This searches all transponders for new channels.
1 Open the menu with »MENU«.
2 Select the line »SOURCE SETUP« with »
V
«
or »
Λ
« and press
»OK«
to confirm.
– The »SOURCE SETUP« menu appears.
Source
Satellite
Automatic Channel Search
Antenna Settings
Signal Information
Digital Manual Tuning
Program Table
Automatic Service Update
Exit
Back
SOURCE SETUP
CA -Module
Not Inserted
Off
Positioner settings
20.09.2010
15:46
OK
3 Select the line »Source« with »
V
« or »
Λ
«
and press
»OK«
to confirm.
Select the input source »Satellite« with »
<
«,
»
>
«, »
V
« or »
Λ
« and press
»OK«
to con-
firm.
4 Select the line »Automatic Channel Search«
with »
V
« or »
Λ
« and press
»OK«
to confirm.
– The menu appears.
5 Select the line »Select Satellites« with »
V
« or
»
Λ
« and press
»OK«
to confirm.
– The »SELECT SATELLITE« menu appears.
6 Select a satellite with »
V
« or »
Λ
« and press
»OK«
to confirm.
7 Select the line »Scan Mode« with »
V
« or
»
Λ
«.
Select the scan mode with »
<
« or »
>
«
(for unencrypted channels, for encrypted
channels only, or both).
8 Select the line »Service Type« with »
V
« or
»
Λ
«.
Use »
<
« or »
>
« to select whether you
want to search for television channels (TV)
only, radio stations only (Radio) or both
(Radio + TV).
9 Select the line »Network Search« with »
V
«
or »
Λ
«.
Select the option »On« with »
<
« or »
>
«
– If the »Network Search« is set to »On«,
the data will be accessed via the new tran-
sponder of the network which has been
set.
10 Start the scan with »
« (red).
Note:
7
If the previously stored channels should be
retained in the channel list and the new
channels found be added to it, then press
»
« (green).
If »
« (red) is pressed, the saved channels
will be deleted from the current channel list.
– The »Results« menu appears, and the scan
for TV channels begins.
– Depending on the number of television
channels received, this can easily take a
few minutes.
– The search is complete as soon as the
»PROGRAM TABLE« appears.
Note:
7
You can abort the search by pressing
»MENU«.
11 Press »MENU« to end the setting.