Filter
Top Products
18
Connecting the antennas
1 Plug the antenna cable of the rooftop antenna into the FM antenna socket
»FM ANT«.
Note:
If no rooftop antenna is available, use the auxiliary antenna supplied. This
antenna provides reasonably good reception of local FM (VHF) stations.
Do not shorten the auxiliary antenna.
2 For medium wave reception, plug the antenna cable of the supplied MW
frame antenna in to the »AM ANT« socket.
Note:
In order to prevent interference, place the MW frame antenna as far as
possible from the system.
Connecting the power cord
1 Insert the plug of the DVD Micro System (»230 V~ 50/60 Hz«) in the
socket.
Note:
If the DVD Micro System does not react when the buttons are pressed, this
may be caused by electrostatic discharge in the area. In this case pull out the
mains plug and insert it into the socket again after a few seconds.
2 Insert the subwoofer power cord plug (»230 V~ 50/60 Hz«) into the
socket.
Inserting batteries in the remote control
1 Open the battery compartment by pressing the marked latch and lifting
the lid.
2 When inserting the batteries (Mignon type, 2 x 1.5 V, UM 3/R 6/AA)
observe the polarity marked in the battery compartment.
3 Close the battery compartment.
Note:
If the DVD Micro System no longer reacts properly to remote control
commands, the batteries may be flat. Be sure to remove used batteries. The
manufacturer accepts no liability for damage resulting from leaking
batteries.
Environmental note:
Batteries, including those which contain no heavy metal, may not be
disposed of with household waste. Please dispose of used batteries in an
environmentally sound manner. Find out about the legal regulations which
apply in your area.
CONNECTION AND PREPARATION
_______________________________________
AUDIO OUT
L
R
COAXIAL OUT VIDEO OUT
Y Pb/Cb Pr/Cr
FM ANT
S VIDEO
TVR
EUR
O
COAXIAL OUT VIDEO OU
T
SUBWOOFER
Y
FM ANT
AM ANT
S VIDEO
A
M
L
O
O
P
A
N
T
E
N
N
A
230 V~ 50/60 Hz
max. 70W
PHASE0° 180°
ON/OFF
I
0
230 V~ 50/60 Hz
max. 75 W
SUBWOOFER IN