Filter
Top Products
10
598-1214-03
Check Operation and Adjustment
Note: When first turned on or when switching
modes wait 1
1
/
2
minutes.
The RANGE control and ON-TIME control are
located on the bottom of the sensor (see Figure 6).
Using your fingernails or a small, flat-head screw-
driver, gently pry the cover until it opens.
1. Check Operation. Set the ON-TIME control to
TEST mode. Walk in front of sensor unit. The
LED indicator light located on the bottom of
the sensor should flash when motion is detected
(see Figure 6).
2. Adjust Sensor. Turn the RANGE control to the
mid position and ON-TIME control to the TEST
position (see Figure 6). Walk through coverage
area noting where you are when the LED begins
to flash. Loosen the clamp screw and move the
sensor to change the coverage area (see Figure
7). Tighten clamp screw when finished. Do not
overtighten clamp screw.
Figure 6 - Motion Sensor Controls (Bottom View)
5 1 TEST
ON-TIME
(MINUTES)
RANGE
MAX
MIN
ON-TIME
Control
Sensitivity
Control
LED Indicator