Filter
Top Products
17
598-1214-03
TROUBLESHOOTING GUIDE
POSSIBLE CAUSE
1. Circuit breaker or fuse is turned off.
2. Interrupted by another device.
3. Does not respond immediately after instal
-
lation.
4. Signals from transmitter are being blocked,
or transmitter is out of range.
5. Weak battery in the transmitter.
6. Dip switches on transmitter and receiver
units do not match.
7. Device is defective.
1. Same as 4, 5, and 6 above.
1. Short term power line failure.
2. Another transmitter on the same channel.
SYMPTOM
Device does not come on.
Device does not turn off.
Device comes on randomly.
SOLUTION
1. Verify circuit breaker or fuse is turned on.
2. Change channels on transmitter and receiver
units.
3. Wait for 90 second initialization period (re
-
mote motion sensor).
4. Check for metal objects that could block the
signal, or reposition the transmitter.
5.
Check battery charge and replace if necessary.
6. Verify dip switch settings on transmitter and
receiver units are set the same.
7. Test using different device.
1. Same as 4, 5, and 6 above.
1. Next transmission from transmitter will reset
receiver to correct state.
2. Change channels on transmitter and receiver
units.