Filter
Top Products
14
598-1214-03
Note: The plastic hanger can be used to hold
the fixture while wiring. Thread the small end of
the plastic hanger through the hole in the center
of the cover plate. Insert the small end into one
of the slots on the mounting strap.
3. Route the wires from the light receiver through
the large gasket holes (see Figure 10).
4. Twist the junction box wires and fixture wires
together as shown. Secure with UL approved
wire connectors (see Figure 10).
5. Align the cover plate and cover plate gasket.
Secure with mounting bolt (see Figure 10).
6. Push the rubber plug firmly into place (see
Figure 10).
7. Not intended for waterproof junction boxes.
Fixture should be surface mount only. Caulk
the wall plate mounting surface with silicone
weather sealant.
8. Adjust the lamp holders by loosening the lock
nuts. Note: Do not rotate the lamp holders more
than 180° from the factory setting.
CAUTION: To avoid water damage and
electrical shock, keep lamp holders 30°
below horizontal.
9. Screw incandescent bulb up to rated wattage
into module. When screwing in the lamps, do
not overtighten.