Filter
Top Products
Operating the TV
Operating the TV 25
The first time you open the favorites list, or after using
the Setup Wizard or Auto Scan in the onscreen display
Channel menu, the Fav list is empty.
During the first-time Setup Wizard, or an Auto Scan,
the TV searches for the TV antenna or cable signal
sources, finds all the available channels, and adds
them to the channel list. If you skipped or canceled
during the initial setup, and have not run the Setup
Wizard or the Auto Scan, there are no channels in the
channel list. To be able to add channels to the favorites
list, the channel must be in the channel list.
To add a channel to the Fav list:
If necessary, first run the Setup Wizard or Auto Scan in
the Channel menu; see “Starting the Setup Wizard” on
page 41 or “Searching for channels” on page 33.
1 Press the Ch+ or Ch– buttons to select the
channel to view.
2 Press the Fav button. The list of favorite
channels opens on an empty line, if
available.
3 Press Ch+ to use the empty line, or press an arrow
button to select a favorite channel entry that you
want to change, and then press Ch+. The current
channel is now in the Fav list.
Displaying program information
Press the Info button on the remote control to display a
banner with information about the program that you
are currently viewing.
Selecting the Input
Source
1 Press the Source button on the remote control, or
on the TV, to open the list of input sources.
2 Press the up or down arrow button on the
remote control, or press the Channel buttons
on the TV, to select the input source to view.
3 Press OK on the remote control, or press Select on
the TV.
Or
Press the Source button again to close the list of
input sources without changing the source.
The list of input sources identifies a connector set on
the rear of the TV:
■ Antenna or Cable is the ANT/Cable In
connector. The label shows the scan source
selection (Antenna or Cable) of the last channel
scan performed by either the Setup Wizard or the
Channel menu.
■ AV1 is the Standard Definition Input AV1
connector set of S-Video In or Video In.
■ AV2 is the Standard Definition Input AV2
connector set of S-Video In or Video In.
■ Component 1 is the High Definition Input
Component In 1 connector set.
■ Component 2 is the High Definition Input
Component In 2 connector set.
■ PC is the PC Input (VGA) connector set.
■ HDMI 1 is the Digital High Definition Input
connector HDMI 1.
■ HDMI 2 is the Digital High Definition Input
connector HDMI 2.
■ HDMI 3 is the Digital High Definition Input
connector HDMI 3 (select models only).
You can change all the labels except Antenna (or
Cable). Use the onscreen display Setup menu Input
Labels option to change the label in the source list; see
“Changing the Input Labels” on page 41.
n
Sometimes the name of the program is not
included in the broadcast. In that case, the
program name is not displayed.
Ch+
Ch-