Filter
Top Products
FIRST TIME USE - 12 -
] REMOTE CONTROL Sensor
Point your remote control at this area when selecting channels, adjusting volume, etc.
^DIGITAL ARRAY
Use this button to enter Digital Array mode. This will allow you to adjust your picture quality to optimum performance. (
See page 37.)
FIRST TIME USE
Q Antenna Input/Output
The remote control allows you to switch between two separate 75-Ohm RF antenna inputs, ANT A and ANT B. ANT A
input can be displayed as a main picture or sub-picture. ANT B can only be displayed as a main picture. (ANT B cannot be
displayed as a sub-picture.) The antenna output labeled "TO CONVERTER" allows the ANT A connection to pass directly
to a different source such as a cable box, when ANT B is displayed as a main picture.
R Audio/Video Inputs 1, 2
The INPUT button will step through each video source and antenna source input each time it is pressed. Use the audio and
video inputs to connect external devices, such as VCRs, camcorders, laserdisc players, DVD players, etc. (If you have
mono sound, insert the audio cable into the left channel jack).
NOTE: You may use VIDEO, S-VIDEO, or COMPONENT: Y-CB-CR inputs to connect to Input 2, but note that
only one of these may be used at a time.
S Monitor Out
These jacks provide fixed audio and video signals which are used for recording. To have S-Video output, S-Video signal
needs to be input to input 1 or input 2.
T Audio to Hi-Fi
These jacks provide variable audio output to a separate stereo amplifier. With this connection, the audio to the stereo can be
controlled by the television's main volume.
U S-Video Inputs 1 and 2
Inputs 1 and 2 provides S-Video (Super Video) jacks for connecting equipment with S-Video output capability.
VY-CB-CR Input: 2 (36UX59B and 32UX59B models)
This input provides Y-CB-CR jacks for connecting equipment with this capability, such as a DVD Player.
NOTE: DO NOT connect standard VIDEO or S-VIDEO to Input 2 when using Y-CB-CR input.
When using the Y-CB-CR input jacks, connect your components audio output to the TV's input 2 Left and Right Audio
input jacks.
Your component outputs may be labeled Y, B-Y, and R-Y. In this case, connect the components B-Y output to the TV's CB