Filter
Top Products
CONNECTING EXTERNAL VIDEO SOURCES - 17 -
NOTE: Completely insert the connection cord plugs when connecting to rear panel jacks. The picture that is played back
will be abnormal if the connection is loose.
If you have an S-VHS VCR, use the S-INPUT cable in place of the standard video cable.
A single VCR can be used for VCR #1 and VCR #2, but note that a VCR cannot record its own video or line output.
(INPUT: 1 in example on page 11.) Refer to your VCR operating guide for more information on line input-output
connections.
CONNECTING A STEREO LASERDISC PLAYER OR DVD PLAYER TO
INPUT 2.
1. Connect the cable from the Y OUT of the Laserdisc or the DVD player to the INPUT 2 (Y) jack as shown on the TV set
below.
2. Connect the cable from the CB OUT or B-Y OUT of the Laserdisc or the DVD player to the INPUT 2 (CB) jack, as
shown on the TV set below.
3. Connect the cable from the CR OUT of the Laserdisc or the DVD player to the INPUT 2 (CR) jack, as shown on the TV
set below.
4. Connect the cable from the AUDIO OUT R of the Laserdisc or DVD player to the INPUT 2 (AUDIO/R) jack.
5. Connect the cable from the AUDIO OUT L of the Laserdisc or DVD player to the INPUT 2 (AUDIO/L) jack.
6. Press the INPUT button until VIDEO:2 appears, to view the program from the Laserdisc or DVD player. The mode
VIDEO:2 disappears automatically after approximately eight seconds.
7. Press the INPUT button to return to the previous channel.