Filter
Top Products
CUSTOM - 40 -
To enter this adjustment mode, you may also select DIGITAL ARRAY from the Set Up menu. However, this will display a
message prompting you to press the front panel DIGITAL ARRAY button.
Use the number buttons to select which point to adjust: [ 1 ] - Upper Left, [ 2 ] - Upper Middle,
[ 3 ] - Upper Right, [ 4 ] - Center Left, [ 5 ] - Center, [ 6 ] - Center Right, [ 7 ] - Bottom Left,
[ 8 ] - Bottom Middle, [ 9 ] Bottom Right.
Press the CURSOR buttons to move the displayed color up, down, left, or right.
Press MENU to change the color you want to adjust.
Press the front panel DIGITAL ARRAY button or the remote control MOVE button when adjustment is done. This will
save your adjustment into memory.
NOTE: Only a momentary press of the DIGITAL ARRAY button is necessary to enter DIGITAL ARRAY convergence
adjustment mode.
Do not press the DIGITAL ARRAY button for more than three seconds. This is only for extreme cases of misconvergence
and requires assistance from service.
Four lines surrounding a crosshatch indicate the point being adjusted. The color of these surrounding lines indicates the
color being adjusted.
To save your adjustment data into memory, press the front panel DIGITAL ARRAY button or the remote control MOVE
Button. If you do NOT wish to save your adjustment data into memory, turn the TV OFF or press the remote control PIP
button. When the TV is turned ON again, your old convergence data will be restored.
When adjusting convergence, always start at the center of the screen.
CUSTOM
This selection contains advanced features which will make TV viewing easier and more enjoyable.
CHANNEL ID
Use this feature to give up to 20 channels a name when ANTENNA signal source is selected and up to 60 channels a name
when CATV1 signal source is selected.