Filter
Top Products
USING THE REMOTE TO CONTROL VCR FUNCTIONS - 30 -
WIRELESS SOUND mode and use the WIRELESS OUT outputs on the rear panel. (see page 62)
Each freeze frame is delayed about 0.1 (1/10) second.
The FREEZE function will display blank sub-pictures when the COMPONENT VIDEO: Y-CB-CR INPUT 2 source
is set as main channel.
USING THE REMOTE TO CONTROL VCR FUNCTIONS
Operating the precoded function for your VCR.
This remote is designed to operate different types of VCRs. You must first program the remote to match the
remote system of your VCR. (refer to page 34 for pre-codes)
1. Turn ON your VCR.
2. Aim the remote control at the front of your VCR.
3. Press and release the VCR button to switch to the VCR pre-coded mode.
4. Hold down the VCR button on the remote, enter the two digit preset code that matches your VCR, as shown on
page 34. The indicator light will flash 3 times if the code was accepted.
5. Aim the remote at the VCR and press the POWER button. The remote will turn off your VCR when the correct
two digit preset code is entered. When this occurs, the remote control is programmed for your VCR. If the VCR
does not turn off, try a different two digit preset code.
6. The remote will now control your VCR.
NOTES:
1. If your VCR cannot be operated after performing the above procedures, your VCR's code has not been
precoded into the remote.
2. In the unlikely event that your VCR cannot be operated after performing the above procedures, please consult
your VCR operating guide.
3. The remote control will remember the codes you have programmed until the batteries are removed from the
remote control. After replacing the batteries repeat the entire programming procedure as stated above.
4. The LAST CH button will act as your VCR ENTER button if required.
5. The SLEEP button will act as your VCR '100' button if required.
Click here for remote CLU-573TSI.
Click here for remote CLU-574TSI.
(1) VCR Button
This button allows the remote to control your VCR by setting it to VCR mode.
(2) PRECODED VCR Buttons
These buttons transmit the chosen precoded VCR codes. For some VCRs, you must press the RECORD button
twice to record a program.
(3) EXCLUSIVE TV Buttons
These buttons are for operating the TV.
MY VCR CODE IS:___________________
NOTE: Refer to instruction manual of the VCR for operation of the buttons exclusively for the VCR.
USING THE REMOTE TO CONTROL CABLE BOX FUNCTIONS
Operating the precoded function for your cable box.
This remote is designed to operate different types of cable boxes. You must first program the remote to match the
remote system of your cable box. (Refer to page 34.)