Hitachi 53SDX01B Projection Television User Manual


 
THE GENIUS REMOTE CONTROL (CLU-572TSI)
34
(6) DVD button
When the DVD button is pressed, it will blink, to indicate the remote is in DVD mode. (See page 35)
7) AV1, AV2, AV3 buttons
When pressed, each of these buttons will blink to indicate the remote is in Audio/Video mode. (See page 36)
(8) CHANNEL selector buttons
CHANNEL selector buttons are used to set FAMILY FAVORITES, CHANNEL MEMORY, etc.
Enter one, two or three numbers to select channels. Enter "0" first for channels 1 to 9, or simply press the single
digit channel you wish to tune then wait a few seconds for the TV to tune. For channels 100 and above, press the
"1" button, wait until two dashes appears next to the channel display on your TV, then enter the remaining two
numbers using the number buttons.
Channel selection may also be performed by pressing CH up (
) or down ( ).
You can also use these number buttons to directly access OSD sub-menu's of your choice. While navigating the
On-Screen-Display's, you will notice that each sub-menu has a number next to it. For example the SET UP menu
has 9 sub-menu's. Pressing the (7) button while in the SET UP menu will take you directly to the CLOCK SET
sub-menu. This makes navigating the menu's faster and easier.
NOTE: The TV may not receive some channels if you are not in the correct SIGNAL SOURCE mode.
(9) SLEEP button
Press this button to display the sleep timer in the lower left corner of the screen. Every subsequent press of this
button will add 15 minutes to this timer, up to a maximum of three hours. Once set, use RECALL when you want
to view time remaining. If the SLEEP button is pressed while the timer is set, it will reset to the original condition.
(10) LAST CHANNEL (LAST CH) button
Use this button to select between the last two channels viewed. (Good for watching two sporting events, etc.)
(11) INPUT button
The INPUT button will select between antenna signal and the three sets of video input jacks each time the button
is pressed. If the Picture-in-Picture is on, the INPUT button will select between the three sets of video input jacks
and both antenna sources when main channel is chosen with the PIP CH button. If the sub-picture is chosen, the
INPUT button will select between the three sets of video input jacks and the ANT A source (ANT B source cannot
be displayed as a PIP sub-picture).