Filter
Top Products
63
Reference
Cannot record or did not
record successfully.
• The remaining blank space on the disc
is insufficient.
• Use another disc.
• The source you are trying to record is
copy protected.
• You cannot record the source.
• When setting the recording channel, the
channel is tuned on the TV’s own tuner.
• Select the channel on the recorder’s
built-in TV tuner.
• When recording to a Video mode disc,
programs that are copy-once protected
cannot be recorded.
• Use a VR mode formatted disc for copy-
once material.
Timer recording is not
possible.
• Clock in recorder is not set to correct
time.
• Set clock to correct time. See “Manual
Clock Set” on page 18.
• Timer has been programmed
incorrectly.
• Reprogram Timer. See “Timer
Recording” on page 39.
• Timer record indicator light does not
appear after programming timer.
• Reprogram Timer.
• Timer recording is not possible unless
channels are previously set.
• Set channels.
Stereo Audio Record
and/or Playback is not
present.
• TV is not Stereo-compatible. • No solution.
• Broadcast program is not in stereo
format.
• No solution.
• The recorder A/V Out jacks are not
connected to TV A/V In jacks.
• Make A/V connections. Stereo is
available only via A/V output from the
recorder.
• The recorder Audio/Video Out is not
selected for viewing at the TV.
• Select AUX or A/V source as TV input.
• The recorder’s TV audio channel is set
to mono.
• Set TV audio channel mode to Stereo.
See “Changing TV Audio Channel” on
page 38.
The remote control does
not work properly.
• The remote control is not pointed at the
remote sensor of the recorder.
• Point the remote control at the remote
sensor of the recorder.
• The remote control is too far from the
recorder.
• Operate the remote control within 7 m.
• There is an obstacle in the path of the
remote control and the recorder.
• Remove the obstacle.
• The batteries in the remote control are
exhausted.
• Replace the batteries with new ones.
Symptom Cause Solution
Resetting the recorder
If you observe any of the following symptoms...
• The unit is plugged in, but the power will not turn on
or off.
• The front panel display is not working.
• The recorder is not operating normally.
...you can reset the recorder as follows:
• Press and hold the POWER button for at least five
seconds. This will force the unit to power off then
turn the unit back on.
• Unplug the power cord, wait at least five seconds,
and then plug it in again.
01EN01DVDS253A(AU).book Page 63 Wednesday, June 7, 2006 3:39 PM