Filter
Top Products
SET UP FOR USE
27
SET UP FOR USE
You can program the tuner to scan only the channels you receive in your area. You
must use the remote control for this procedure.
NOTES:
• Channel memory programming is NOT needed when connected to a cable box
or satellite box as in Fig 4 on page 11 or Fig 5 on page 12. In this case with your
remote, select the VCR to channel 3 or 4 the same channel as located on the back
of VCR (CH3 or CH4). Then the channel you wish to record or view may be
selected on the cable box or satellite box
• Follow the steps below once. Repeat it only if there is a power failure or if the VCR is
unplugged for more than 30 seconds. (In these cases, the programmed channels are
erased.)
• You must follow the steps below before attempting to play or record a video tape. If
you want to play or record a video tape BEFORE programming the tuner, you must first
turn off the VCR. Then, press the POWER button again to turn ti back on. To program
the tuner again, see "CHANNEL SET UP AGAIN" on page 16.
CHANNEL SET UP (Automatic)
1 Plug in the VCR power cord
Plug the VCR power cord into a standard AC outlet.
Remember: If your cable box or satellite box is connected as in Fig 4 on page 11 or Fig
5 on page 12, you DO NOT have to set up the channels. Just select the TV and VCR to
channel 3 or 4 and also have the CH3/CH4 switch on the back of the VCR to match the
channel you selected (CH3 or CH4). Now select the Box to the channel you wish to
view or record.
2 Select channel 3 or 4 on the TV
Turn on the TV and set the TV to channel 3 or 4. Now set the CH3/CH4 switch on the
back of the VCR to match the channel selected on the TV.