Filter
Top Products
Basic Operations (VCR Plus 4-Recording)
_sc_ve_ _ann_ 37 C_n_] 33 Di_l_ve_
In the example above none of the cable channels match, all of them need
to be assigned to VCR Plus+ channel codes.
Matching Broadcast CH Numbers to VCR Plus+ Channels
For Home Antenna or Cable (No Cable Box) Setup
1. Press GUIDE, then press 4 to select VCR PLUS SETUP.
You will see the screen as shown below.
2. A small arrow points to a blank "--" in the Channel column. If your
broadcast channel number is the same as the VCR Plus+ channel in your
TV listing, do not enter any number. Press CHANNEL up or down to
position a nonmatching station next to the arrow.
3. If your broadcast channel number is not the same as the VCR Plus+
channel in your TV listing, use the number buttons to assign the broadcast
channel to the corresponding VCR Plus+ channel.
If you enter a wrong digit, press CLEAR and enter the correct one.
In the example below broadcast channel #38 is assigned to VCR Plus+
channel #42.
4. Repeat step 3 for all channels that need to be assigned.
5. Press GUIDE to end the setup procedure. You are ready to begin
delayed recording with VCR Plus+.
Cable with a Cable Box or Cable with a Cable Box and Splitter Setup
Use this setup procedure if you receive all channels through a cable box.
CABLE BOX SET tells the VCR how to record or to view programs from
the cable box. If your cable box can be controlled by a remote, the VCR
may be able to tune it to the channel you want to record or view. Before
you begin, you need to know the output channel for your cable box.
Usually this is either 03 or 04, but it could be 02 through 13. Consult your
cable company if you're not sure.
1. Connect the Cable Box, VCR and TV. See page 50.
2. Press GUIDE, then press 5 to select "INITIAL SETUP MENU".
3. Press 1 to select CATV2 with the ANT/CATV1/CATV2 setting, then
press 7 to select "CABLE BOX SET" menu.
4. Press 2 to answer "YES" to the question "Is a cable box being used with
the VCR for all channels?" You will then see this screen: