Filter
Top Products
GB50
User’s Manual
7. Installation
2. Manual Search
You can search channels manually by searching parameters, using the MUX information.
1. Select Manual Search using the
/ button and press the
OK or
button.
2. Select Channel using the / button and press the
OK or
button. Select one of channels using the /
button and press the OK button. When entering channel
value, the appropriate frequency value is displayed.
3. Select Frequency using the
/ button and press the
OK or
button. Enter the frequency using the
NUMERIC(0-9) buttons and press the OK button. When
entering frequency, the appropriate channel for the
entered frequency is automatically displayed on channel.
4. Select Band Width using the / button and press the OK or button to select from 7 and 8MHz.
5. Select Network Search using the
/ button and press the OK or button to select Enable/Disable.
6. Select Search using the
/ button and press the OK button. Channel search will activate.
3. Antenna Power
Make sure to set the Antenna Power to On when you connect an active antenna to the ANTENNA IN
connector on the rear of the product. Select Antenna Power using the / button and press the OK or
button to select On/O .
Antenna Power On
In case you are using an active antenna that has its power supplied by the aerial, the antenna power
should be set to On.
• Active antenna
Power supply from external power adaptor is not necessary. (ex. Indoor Antenna)
Antenna Power O
In case you are using a passive antenna or an active antenna with its own power source, the antenna
power should be set to O . (The default value is O .)
Caution: Be sure to turn o the antenna power when using an active antenna with its own power
source. Damage may occur to the antenna if left on.