Filter
Top Products
Copyright©2005 ILY Enterprise, Inc. All rights reserved.
21
4.11.8 Auto Prescan
This setting allows you to automatically scan if the source DVD can be read correctly and also
tests the reading speed.
Press the ENT button to enter Auto Prescan.
Use the arrow button to change the “On” or “Off” Setting.
Then press ENT or press ESC to return to the 11-08 menu.
4.11.9 Eject Disc
The Eject disc setting allows three choices: Eject Good Only, Eject All Disc and Do Not Eject.
Press ENT button to enter the following figure:
Use the arrow button to select Eject Good Only.
Then press ENT or press ESC to return to the 11-
09 menu.
Use the arrow button to select Eject All Disc,
then press ENT or press ESC to return to the 11-
09 menu.
Use the arrow button to select Do Not Eject. Then press
ENT or press ESC to go back to the 11-09 menu.
4.11.10 Burn on the Fly
This setting lets you control the burning methods. When the setting is “On”, the data will copy
directly from source drive to the target drives. When the setting is “Off”, the data will load into a
partition of the hard drive first. Then, the copying will be completed.
Press ENT button to enter Burn On The Fly.
Use the arrow button to change the On or Off
setting. Then press ENT or press ESC to return to
the 11-10 menu.
If the system does not have a hard drive connected,
the LCD will show the following message:
4.11.11 Burn Mode
This setting lets you control the burning methods. There are two modes: Disc At Once (DAO) or
Track At Once (TAO). Default setting is DAO. Some DVD writers may support different writing
methods. If the method selected is not supported, duplicator will automatically switch to the other
one.
11-08. Setup
Auto Prescan
Auto Prescan
Off
11-09. Setup
Eject Disc
Eject Disc
Eject Good
Only
Eject Disc
Eject All Disc
Eject Disc
Do Not Eject
11-10. Setup
Burn On The Fly
Burn On The Fly
On
There is no HDD !