Filter
Top Products
Copyright©2005 ILY Enterprise, Inc. All rights reserved.
27
Press the ENT button to enter Load Default.
Use the arrow button to change settings. When
“Yes” is selected, the duplicator will return to its
factory’s default setting.
The LCD message will show that the setting has
been changed with the following message:
Chapter 5 Trouble Shooting
1. There’s no display on the LCD or the unit does not operate when you power on.
• Please check the power cable connection and that the power
outlet is normal.
• Turn off the power of the machine, open the case of duplicator, and check if
there are any problems with the power cable.
2. The LCD shows the Error message.
• During an operation such as Copy, Test, Compare and Verify, you can press the ESC
button to abort the operation. An Error message will be shown on the LCD.
Some DVD writers will cause the duplicator to reset. You have will need to
re-start the power to get the duplicator to function properly.
• A failed reading may cause an error message to show on the LCD display.
Change the master DVD and try again.
• During the operation, if message shows error read, buffer under run or writing error
occurs, the LCD will show an error message like: Pass xx, failed xx.
• If there is no device connected and detected by duplicator during power-on,
the duplicator will show an error message on the LCD before entering the main menu.
3. The DVD-ROM cannot read disc and shows error message.
• Check the format of the master DVD or master DVD itself for damage.
• Use any of the DVD-Writers to read the master. If it works, the DVD-ROM may be
defective or incompatible with the DVD-ROM.
4. The buttons do not function.
• May still be busy on task.
• Button malfunction.
• Faulty board.
5. Copy is completed but DVD-R disc is not readable / executable?
• Use the compare function to check.
• Insert into another DVD-ROM drive to test.
6. The failure rate is high.
• Lower the speed of the DVD-Writers and try again.
• The quality of blank disc is poor.
• Check for latest firmware version.
12-10. Adv Setup
Load Default
Load Default
Config? Yes
Load Default
OK