Filter
Top Products
Copyright©2005 ILY Enterprise, Inc. All rights reserved.
9
• Failed discs will remain in writers. The default setting is to keep failed discs in the writers,
but this can be changed. Press the buttons on the drivers to take the failed DVDs.
• During the duplication process do not press any button because interruption will harm the
device. DVDs will be damaged.
2. Without a hard drive installed
If you don’t install a 3.5” hard disc, the operation procedures will be as follows:
• Place the master disc in the DVD-ROM.
• Switch to function 1, Copy, by pressing arrow button. Place blank DVD-R or DVDRW
discs into all the DVD writers. Press ENT to start.
• When Copy completes, the passed DVDs will eject automatically. The default is to eject
automatically, but this can be changed.
•
Failed DVDs will remain in the writers. The default is keeping failed DVDs in the writers,
but you can change it. You need to press the “eject” buttons on the writers to take the
failed DVDs.
ATA-66 Cable Layout:
Please identify the two different kinds of cable before the hardware installation.
Chapter 4 Function
4.1 Copy
Use this function to copy data from a source DVD directly onto blank DVD discs. Before copying
make sure that the source DVD is placed into DVD-ROM. If you have a HDD, make sure there is
data in your HDD partition. If you are not sure about the success of your duplication job, you can
use function 2 Test to simulate the copying process first.
Select function 1. Put a source DVD into DVD-ROM and blank DVD disks into DVD writers. DVD
rewriteable discs containing old data are usable, too.
LCD will show the process of copying
information as the following screen:
When copying is completed, the LCD will display as
the following screen:
Discs correctly copied will be ejected automatically
and failed ones will remain in the writers.
4.2 Test
Copying-24X 0%
650.0MB 74:00
1
.
Copy
OK: 03