Filter
Top Products
12
If you have selected H/O
Select units of measure- inlb, ftlb, etc. using
Note: High Output devices usually produce an output voltage of approximately 1-2 Volts. This
analogue voltage signal will not be exact and may not be linear. If you are using a device that
has a nominal 1Volt output, we suggest that you multiply the span of your transducer by 2.5 to
determine the new span setting.
Type in your new span; press
Type in Serial Number; press
Screen will indicate ‘End of Set-up’; press to return to main menu
Connect your high output device and select measure mode
(refer to instruction sheet for measure mode only)
Use an independent measuring device to apply a torque to the transducer and check the read-
ing on the independent unit against the reading shown on the ETA. It will be necessary to return
to the ‘Edit Tx’ menu option and adjust the span setting until the two readings agree. You may
have to repeat the above procedure several times until your high output transducer is correctly
calibrated.
If you have selected KPD
Select location of decimal point using then press
Select Parity- Odd, Even or Disabled using then press
To set-up another transducer press
Select another memory (B to I) using the keys and press
To return to main menu press
Enter
Enter
MENU
Enter
Enter
MENU
1
Enter
MENU
7529_eng.fm Page 12 Wednesday, November 12, 2003 8:57 AM