Filter
Top Products
57
Sub-Group Grouping of samples to enable analysis, with an allowable range of 1-50.
Threshold Torque Value
Level of torque in which a signal must rise above and then fall below to be
considered a valid torque cycle. This may be set in the range of 1 to 50% of
rated span or the Min Torque Value, whichever is the lower.
Units of Measure
It is possible with ETA to read a transducer calibrated in for instance, Nm,
and convert internally to display and store in any of the other torque units.
Vertical Prompt Collection of data by round, where a full sub-group is collected for a char-
acteristic, before stepping to the next characteristic.
Vertical Plus Prompt
Identical in procedure to that of Vertical mode except that before stepping to
the next characteristic, ETA5 will prompt for the fitting of a transducer (even
though the correct one is installed) and will require the ENTR key to be
pressed. Stepping to the next characteristic, ETA5 will prompt for the fitting of
a transducer (even though the correct one is installed) and will require the
ENTR key to be pressed.
7529_eng.fm Page 57 Wednesday, November 12, 2003 8:57 AM