Filter
Top Products
19
To set up a Characteristic - ETA5 ONLY
To set up a job
To start, press
press
plug in transducer
press (Configure)
press (Edit Char)
Type in Job Name ______________________ , press
Alternatively, when the cursor is flashing, you may connect a Bar Code Reader to the Printer/PC
connector on the back of the ETA5 and scan the information from a barcode. Scan across the
label (from left or right) and watch the display. If the flashing cursor disappears, the reading has
been captured; wait a few seconds for the reading to be displayed. If not, re-scan until the data
is accepted.
When the information is displayed on the screen, press
Type in number of samples __________________ , press
Type in number of subgroups ________________ , press
Select transducer ID using , press
Select units of measure using , press
Select ‘Peak’, ‘Impulse’, or ‘Click’ using ; then press
Select measurement direction using ; then press
Select cycle end time using ; then press
ON
MENU
1
1
Enter
Enter
Enter
Enter
Enter
Enter
Enter
Enter
Enter
7529_eng.fm Page 19 Wednesday, November 12, 2003 8:57 AM