Filter
Top Products
20
NS-19E310A13 Insignia 19" LED TV
www.insigniaproducts.com
Using the remote control
Installing remote control batteries
The remote control model number is on the front of
the remote control.
To install remote control batteries:
1 While pressing the release latch on the back of
the remote control, lift the battery
compartment cover off the remote control.
2 Insert two AAA batteries into the battery
compartment. Make sure that you match the +
and – symbols on the batteries with the + and –
symbols in the battery compartment.
3 Replace the battery compartment cover.
Aiming the remote control
To aim the remote control:
• Point the remote control towards the remote
sensor on the front of your TV.
Turni ng on your T V fo r the
first time
The first time you turn on your TV, the Setup Wizard
opens. The Setup Wizard guides you through
setting up basic settings including the menu
language, time setting, picture mode, TV signal
source, and the channel list.
To set up your TV:
1 Make sure that you have:
• Installed the remote control batteries. (See
page 20
for details.)
• Connected an antenna, cable TV, or satellite
TV. (See page 10
through 13 for details.)
• Connected the power cord. (See page 10
for
details.)
2 Press (power) to turn on your TV. The Choose
Your Menu Language screen opens.
3 Press
S
or
T
to highlight the language you
want, then press ENTER. The Choose Your Time
Setting screen opens.
4 Press
S
or
T
to highlight Mode, then press
W
or
X
to select Manual (to set the date and
time manually) or Auto (to set the date and time
automatically from a TV signal source based on
the time zone you select).
Cautions
• Batteries should not be exposed to excessive
heat, such as sunshine, heat registers, or fire.
• Battery chemicals can cause a rash. If the
batteries leak, clean the battery compartment
with a cloth. If chemicals touch your skin, wash
immediately.
• Make sure that batteries are disposed of
correctly. Do not burn or incinerate.
Notes
• Do not mix batteries of different types.
• Do not mix old and new batteries.
• Remove batteries when the charge is depleted.
• If the remote control is not going to be used for
an extended period of time, remove the
batteries.
Note
Your remote control may vary from the images
shown in these steps.
Note
If you select Auto, the displayed time will be
incorrect until your TV gets the correct time from a
TV signal source.