Filter
Top Products
23
Insignia 39"/42"/46" 1080p LED TV
www.insigniaproducts.com
C If you select Satellite Box, a message asks
how you connected the satellite box to
your TV:
• Select AV, Component, or HDMI, then
press ENTER if you connected a satellite
box to your TV using one of these cables.
Read the message, then press ENTER to
close the wizard.
• Select Coaxial, then press ENTER if you
connected a satellite box to your TV using
a coaxial cable. Read the message, then
press ENTER to start the channel scan (VHF
channels only).
12 To watch TV, press INPUT, press
S or T to
highlight the video input source for your TV in
the Input source list, then press ENTER.
• If your TV is connected to an antenna, cable TV
(no box), or cable or satellite TV box using a
coaxial cable, select TV.
• If your TV is connected to a cable or satellite
box using an HDMI cable or HDMI cable with a
DVI adapter, select HDMI 1, HDMI 2 or
HDMI 3.
• If your TV is connected to a cable or satellite
box using a component video cable, select
Component.
• If your TV is connected to a cable or satellite
box using a composite video cable, select AV.
Understanding the basics
Turning your TV on or off
To turn your TV on or off:
1 Make sure that the power cord is connected to a
power outlet.
2 Press (power) to turn on your TV. The power
indicator turns off.
3 Press (power) again to turn off your TV. Your
TV enters standby mode, and the power
indicator LED turns red.
Selecting the video input source
To select the video input source:
1 Turn on your TV, then press INPUT. The Input
source list opens.
2 Press
S or T to select a video input source, then
press ENTER.
You can also press a Quick Launch Input button to
select the video input source.
• Press TV to select TV (if your TV is connected to an
antenna, cable TV (no box), or cable or satellite TV
using a coaxial cable).
• Press VIDEO one or more times to select
component or composite input.
•Press HDMI one or more times to cycle between
the HDMI inputs.
Note
You can press EXIT to stop the auto channel search,
but you will need to run the auto channel search
again to create a channel list.
How did you connect the
AV, Component, or HDMI
Coaxial
Move
OK
ENTER
ME NU
EXIT
Exit
Previous
Selec t
Satellite Box to the TV?
Select if you have a satellite box
Warning
When your TV is in standby mode, it is still receiving
power. To completely disconnect power, unplug the
power cord.
Note
If your TV does not receive an input signal for several
minutes, it automatically goes into standby mode.
TV
AV
HDMI 1
HDMI 2
HDMI 3
USB
Input source
Component
VGA