Filter
Top Products
43
HDMI and Progressive Settings
This section explains how to turn on the HDMI OUT and
change the video resolution when your TV or projector
is connected to the HDMI OUT.
The DVD player supports the following resolutions:
Auto:
The resolution is automatically set to the native resolu-
tion of the TV connected to the HDMI OUT.
If the DVD player does not support the TV’s native res-
olution setting, the resolution 480p/576p will be used.
480p (480p/576p) (default):
The setting displayed depends on the country in which
you purchased the DVD player.
720
×
480p 60Hz or 720
×
576p 50Hz
Also output by the DVD player’s analog video outputs.
With this setting, component video output will be pro-
gressive.
720p:
1280
×
720p 50/60Hz
Not output by the DVD player’s analog video outputs.
1080i:
1920
×
1080i 50/60Hz
Not output by the DVD player’s analog video outputs.
Tip:
These settings can also be changed by using the onscreen
setup menus (see pages 46, 47).
Note:
• Be sure to choose a resolution that’s supported by your
TV. If you select a resolution that your TV doesn’t
support, there will be no picture.
If your TV supports progressive video, you can set the
DVD player to progressive and enjoy progressive video
on your TV. If your TV doesn’t support progressive
video, set the DVD player to interlaced.
While the HDMI OUT is on, the component video out-
put is fixed at progressive and depending on the selected
resolution there may be no output, so turn off the HDMI
OUT before changing this setting.
HDMI
Resolution
Resolution
Setting the HDMI
1
Press the DVD player’s [HDMI]
button to turn on HDMI.
2
Press the [Resolution] button
repeatedly to change the HDMI
resolution.
The first button press displays the cur-
rent resolution onscreen. Press the but-
ton again while the resolution is
displayed to change the setting.
Remote
controller
Selecting Progressive or Interlaced
1
Press the DVD player’s [HDMI]
button to turn off HDMI.
2
Use the [Resolution] button to
select progressive or interlaced.
The first button press displays the cur-
rent setting onscreen. Press the button
again while the setting is displayed to
change the setting.
The PROGRESSIVE indicator appears
on the display when progressive is
selected.
Remote
controller