Filter
Top Products
20
The AV-61S902 is designed to be the center of a home theater system. The AV-61S902 features a 50 Watt built-in
amplifier with output jacks for up to four speakers (2 front, 2 rear-surround). The diagram below shows the con-
nections and general speaker placement for a typical Surround-Sound home theater connection.
Home Theater
FRONT
SURROUND
REAR
LR
AUDIO OUT
LR
LR
*1
*1
• If you only have two external speakers, set the DOLBY PRO LOGIC MODE to “PHANTOM”. When using PHAN-
TOM, it is not necessary to connect to the AUDIO OUT (FRONT L/R) terminal.
• For optimal performance from your Home Theater system, please see the following sections in this guide: “TV
Speaker”, page 44, “Sound Mode”, page 45. These sections will help you to configure your system for its best
audio performance.
Amplifier
Amplifier
L
R
Surround Surround
L
R
TV
Approx. 45
degree
Surround
Surround
Connections
1) Connect the white audio cable from the left audio input of the amplifier for the front sound to the left front audio
out jack.
2) Connect the red audio cable from the right audio input of the amplifier for the front sound to the right front
audio out jack.
3) Connect the white audio cable from the left audio input of the amplifier for the rear surround sound to the left
surround rear jack.
4) Connect the red audio cable from the right audio input of the amplifier for the rear surround sound to the right
surround rear jack.
• For optimal effect, install the surround speakers at least 1 metre above the heads of seated viewers.
Positioning the Speakers
AV-61S902(E) 1/12/01 3:15 PM Page 20