Filter
Top Products
Filename [DR-MH30UJ_04Name.fm]
Masterpage:Left+
24 EN
INITIAL SETTINGS
Page 24 Monday, 12 July 2004 14:10
The following procedure is required if you receive your TV
channels through a cable box (descrambler) and/or if you receive
satellite channels through DBS (Direct Broadcast Satellite)
receiver. The Controller allows the unit to automatically switch the
cable box and/or DBS receiver’s channels during timer recording.
NOTES:
● The Controller is effective for “VCR Plus+
®
Timer Programing”
(੬ pg. 46), or “Manual Timer Programing” (੬ pg. 48).
● When connecting your cable box, refer to its instruction manual.
Installing Controller
1 If both a cable box and a DBS receiver are used, position the
Controller so its signal reaches the receiving windows of both the
cable box and DBS receiver.
2 Fix securely using the adhesive strip attached on the back of the
Controller.
3 Connect the controller to the unit.
a
If your cable box or DBS receiver does not have audio/video
output connectors
Connect the RF output connector on the cable box or DBS receiver
to the ANTENNA IN connector on the rear of your unit.
If your cable box or DBS receiver has audio/video output
connectors
Connect the audio/video output connectors on the cable box or
DBS receiver to the AUDIO/VIDEO INPUT connectors on the rear
of the unit.
● If both a cable box and a DBS receiver are used, it is recommended
that you connect the DBS receiver to your unit’s AUDIO/VIDEO
INPUT connectors and the cable box to your unit’s ANTENNA IN
connector.
4 Connect the Controller to the CABLE BOX connector on the rear
panel.
Setting Brand And Channel
After installation, set the cable box and/or DBS receiver’s brand
and channels correctly; otherwise, the Controller cannot work
correctly.
1 Turn on the cable box and/or DBS receiver.
2 Press SET UP to access the Main Menu screen.
3 Press we to select “INITIAL SET UP”, then press t.
4 Press we to select “STB SET UP”, then press t.
5 Press rt to select “CABLE
BOX SET” or “DBS RECEIVER
SET”, then press ENTER.
6 Press rt to select “CABLE
BOX OUTPUT CH” or “DBS
RECEIVER OUTPUT CH”, then
press ENTER.
Cable Box and/or DBS Receiver Control
Setting
Cable box or DBS receiver
Controller
(suggested locations)
Your unit
CABLE
BOX
Transmitter
To ANTENNA IN
Controller
To RF output To Audio/video
output
or
Your unit
To AUDIO/
VIDEO INPUT
Cable box or DBS receiver
● Turn on the unit.
● Turn on the TV and select the AV mode.
● Slide the TV/CABLE/DBS/DVD switch to DVD.
rtwe
ENTER
SET UP
CABLE/DBS
DVDTV
PRESS [SET UP] TO EXIT
ENTER
SELECT
EXIT
SET UP
SELECT WITH [ ] THEN PRESS [ENTER]
STB SET UP
CABLE BOX SET DBS REC VER SET
TUNER SET UP CLOCK SET UP
DVD VIDEO SET UP INITIAL SET UPFUNCTION SET UPHDD/DVD SET UP
PRESS [SET UP] TO EXIT
ENTER
SELECT
EXIT
SET UP
SELECT WITH [ ] THEN PRESS [ENTER]
INITIAL SET UP > CABLE BOX SET
CABLE BOX BRAND
CABLE BOX OUTPUT CH
1
OFF
TEST MODE
DR-MH30UJ_00.book Page 24 Monday, July 12, 2004 3:17 PM