Filter
Top Products
38
Timer Recording Troubleshooting
Even though the timer is set, the recorder will not
record when:
• The power has been unplugged or the power
supply has been stopped.
• There is no disc (or tape) loaded.
•Anon-recordable disc (or tape) is loaded.
• Disc Protect is set to [ON] in the Disc menu
(see page 23).
• There are already 99 titles (DVD-RW, DVD-R),
49 titles (DVD+RW, DVD+R) recorded on the
disc.
You cannot enter a timer program when:
•Arecording is already underway.
• The time you’re trying to set has already
passed.
• There are already 16 timer programs set.
If two or more timer programs overlap:
• The earlier program takes priority.
• When the earlier program finishes, the later
program starts.
• If two programs are set to start at exactly the
same time, the program entered first takes
priority.
If the disc is damaged, the recording may not
complete successfully. In this case even though the
Check field shows [Rec. OK], it may not be.
To record one TV program while
watching another
1. Press TV/VCR to select the TV mode during
recording. The TV indicator appears.
2. Using the TV, select the channel to be viewed.
Tip (VCR mode only)
Always use PAUSE (X) for best results when making
changes during recording .
For example: To change channels during recording, first
press PAUSE (X) to put the unit in pause mode. Then
select the desired channel on the Recorder, and press
PAUSE (X) again to resume recording.