JVC HR-DD858EH VCR User Manual


 
EN 19
Names of
special-effects
playback
Reverse Forward
Search Play Slow-Motion *Still Slow-Motion Play Search
-9x -7x -5x -3x -1x -1/6x -1/18x 0 1/18x 1/6x 1x 2x 3x 5x 7x 9x
-7x -3x -1/6x -1/18x 0 1/18x 1/6x 1x 2x 5x 9x
Audio is output.
Audio is not Audio is Audio is not
Audio is output.
output. output. output.
TimeScan
Speed LP
Speed SP
Audio output
* Still mode cannot be engaged using the remote control's or button. Still mode can be engaged by
pressing the PAUSE button.
The speed is shown during TimeScan in the upper right corner of the TV screen for approx. 5 seconds. (The display may be
distorted.)
To resume normal playback, press PLAY.
When using the recorder's TIME SCAN SHUTTLE ring, the playback speed may not change in the correct step if it is turned
too fast.
Picture and audio may become distorted when the recording speed changes. When this happens, resume normal playback
once, and then try using TimeScan again.
The picture may be noisy or there may be a loss of colour when you change the playback speed. (More noise will appear with
LP recordings.)
Noise may appear or the upper part of the picture may be distorted during still, frame-by-frame playback, 2x search of LP
recordings, or depending on the tape being used.
Picture may appear distorted in comparison to normal playback.
In TimeScan mode there will be a time lag between the video and the audio and noise may appear in the audio signal.
TimeScan sound quality will differ in comparison to normal playback.
When material such as music videos where there is non-stop sound (very few breaks in the soundtrack) are viewed at 2x
normal speed, the audio playback may be faster than normal.
When the playback direction is reversed, it takes approximately 6 seconds until sound is heard.
Picture will be monochrome with an LP-recorded MESECAM tape during TimeScan.
When playing back an NTSC tape, the speeds differ from those listed above and are not shown on the TV screen.
Also, depending on the type of tape being used, the picture may be distorted and there may be a loss of colour even when in
the TimeScan mode.
If you don't want to hear TimeScan audio, set "TIME SCAN AUDIO" to "OFF" (See below).
%
%
TimeScan Audio
The audio output can be set ON/OFF during TimeScan.
Select ON/OFF as required.
* The default setting is "ON".
1 Press MENU to access the Main Menu screen.
2 Move the highlight bar (pointer) to "MODE SET" by
pressing
%
, then press OK or .
3 Move the highlight bar (pointer) to "TIME SCAN
AUDIO" by pressing
%
, then press OK or to select
"ON" or "OFF".
4 Press MENU to return to the normal screen.
%
%
MODE SET
AUTO TIMER OFF
O. S. D. ON
B. E. S. T. ON
AUTO SP=LP TIMER OFF
AV2 SELECT AV2
COLOUR SYSTEM PAL/NTSC
TIME SCAN AUDIO ON
[5∞] =
[MENU] : EXIT
MODE SET
AUTO TIMER OFF
O. S. D. ON
B. E. S. T. ON
AUTO SP=LP TIMER OFF
POWER SAVE OFF
AV2 SELECT AV2
COLOUR SYSTEM PAL/NTSC
NEXT PAGE
[5∞] =
[MENU] : EXIT
HR-DD858E HR-DD858EH
PREVIOUS PAGE
TIME SCAN AUDIO ON
[5∞] =
[MENU] : EXIT