JVC HR-J259EE VCR User Manual


 
EN 37
%
SELECT STATION NAME
CHARACTER
1
Press PUSH JOG until
the first letter of the station
name begins blinking.
ENTER NEW CHARACTER
2
Press PUSH JOG %fi to cycle through the characters
(A–Z, 0–9, –,
*
, +, (space) ) and stop when the
desired character is indicated, then press PUSH JOG
to enter. Enter the remaining characters the same way
(maximum of 4).
After entering all characters, press OK.
The Channel List screen appears.
If you make a mistake, press PUSH JOG until the
incorrect character begins blinking. Then enter the
correct character by pressing PUSH JOG
%fi
.
CLOSE CHANNEL LIST
SCREEN
3
Press MENU.
[
%
%
Set Stations (B)
Perform steps 1 and 2 of "Storing Channels Manually" on
page 34 to access the Channel List screen and then perform
step 1 and 2 of "Set Stations (A)" on the left before continuing.
Set station names other than the ones registered in your recorder.
TV System Selection - When
you see the picture but hear
no audio
Perform steps 1 and 2 of "Storing Channels Manually" on
page 34 to access the Channel List screen before continuing.
SELECT CHANNEL
POSITION
1
Press PUSH JOG
%
until the channel position you
want to change its TV system begins blinking, then
press OK. The Manual Channel Set screen appears.
SELECT TV SYSTEM
2
Press PUSH JOG until TV system setting (D/K or B/G)
begins blinking and then press PUSH JOG
%
to select
the appropriate TV system. Refer to the table on page
34 also.
RETURN TO CHANNEL LIST
SCREEN
3
Press OK.
The Channel List screen appears.
Repeat steps 1 through 3 as necessary.
CLOSE CHANNEL LIST
SCREEN
4
Press MENU.
%
TV
PR CH ID FINE SYSTEM
06 CH45 ARD +/– D/K
[
5
] : A-Z, 0-9
[
] : CURSOR +=
: OK
[MENU] : EXIT