JVC HR-J746MS VCR User Manual


 
28
PLAYBACK
Basic
Playback
The easiest, most basic operation possible with your video
recorder is tape playback. Already-recorded signals on a video
tape are read by your video recorder and displayed on your TV
just like a TV programme.
LOAD A CASSETTE
1
Make sure the window side is up, the rear label side is
facing you and the arrow on the front of the cassette is
point toward the recorder. Don’t apply too much
pressure when inserting.
The recorder power comes on automatically and the
counter is reset to 0:00:00.
If the record safety tab has been removed, playback
begins automatically.
FIND PROGRAMME START
POINT
2
If the tape is advanced past the start point, press 2
or turn the RECH. VAR. ring to the left.
To go forward, press 2 or turn the RECH. VAR. ring
to the right.
START PLAYBACK
3
Press 4($). “BEST” appears blinking in the recorder's
display panel for 5 seconds ( pg. 36).
STOP PLAYBACK
4
Press 5 on the remote or 5/8 on the recorder’s front
panel. Then press 5/8 to remove the cassette.
Usable cassettes
Compact VHS camcorder recordings can be played on
this video recorder. Simply place the recorded cassette
into a VHS Cassette Adapter and it can be used just like
any full-sized VHS cassette.
This video recorder can record on regular VHS and
Super VHS cassettes. However, it will record and play
back regular VHS signals only. It is not possible to play
back a recorded Super VHS tape.
Turn on the TV and select the AV mode.
q
12
45
3
6
8
0
7
9
2
4
1
3
RECH. VAR.