JVC HR-J746MS VCR User Manual


 
33
Remote A/B Code Switching
The remote control is capable of controlling two JVC video
recorders independently; one set to respond to the remote
control’s A code control signals and another set to respond to B
code control signals. The remote control is preset to send A
code signals because your video recorder is initially set to
respond to A code signals. You can easily modify your video
recorder to respond to B code signals.
REMOVE POWER SUPPLY
1
Unplug the mains power cord from the mains outlet.
SET A/B CODE SWITCH
2
Set to B.
RE-SUPPLY POWER
3
Plug the mains power cord back into the mains outlet.
TURN THE RECORDER ON
4
Press on the remote control. The recorder will now
only respond to B code signals.
NOTE:
Some TV sets may malfunction in response to the B mode. If
this happens, switch back to the A mode.
ACTIVATE SCENE FINDER
1
Press RECH. SEQ. The recorder starts forward search for
5 seconds and then fast-forwards 10 minutes on the
counter. This cycle is repeated until the end of the tape
is reached.
To start Scene Finder in the reverse direction, press
RECH. SEQ. and then turn the RECH. VAR. ring to the
left (or press the remote's 2 button) within 2
seconds. This cycle is repeated until the beginning of
the tape.
During Scene Finder, the following indications appear
on the display panel:
STOP SCENE FINDER
2
Press 5.
NOTES:
During Scene Finder search, you can also hear the tape
sound. During fast forward or rewind, you hear the current TV
sound instead.
Scene Finder does not function during Index Search.
This function helps you check contents of unlabeled recorded
tapes at the touch of a single button.
NOTE:
Scene Finder cannot be used when the recorder is in the Record
mode.
Scene Finder
10 minutes
on counter
323232
Search Search Search
5 seconds10 minutes
on counter
5 seconds 5 seconds
Next Function Memory
You can set your recorder's power to go off automatically after
the tape is fully rewound. Before starting, make sure the
recorder is in the Stop mode.
For Automatic Power Off After Tape Rewind . . .
. . . press 2, then press
within 2 seconds.
NOTE:
If you want the power to be turned off automatically when the
counter reads “0:00:00” (instead of at the beginning of the
tape), press M. COMPTEUR so that the “M” mark appears
before pressing
2
.
Counter Memory
Returns to the counter reading of “0:00:00” to conveniently find
a specific place on the tape automatically.
SET COUNTER MEMORY
1
Press 0000 during playback at a point you wish to
locate later. The counter reads “0:00:00”. Then press M.
COMPTEUR, and “M” appears in front of the counter
digits.
ACTIVATE COUNTER
MEMORY
2
When you wish to return to the designated point, press
5 and then 2 or 3.
The tape rewinds or fast-forwards and stops at about
0:00:00 automatically.
To cancel Counter Memory, press M. COMPTEUR
again.