JVC HR-S8965EK VCR User Manual


 
advanced features50
Editing
L-1 OUTPUT/INPUT Setting
The AV1 (L-1) IN/OUT connector accepts and delivers either a composite signal
(regular video signal) or a Y/C signal (a signal in which the luminance and
chrominance signals are separated). Set
L-1 OUTPUT and L-1 INPUT to the appro-
priate mode depending on the type of unit connected to the rear panel
AV1 (L-1)
IN/OUT
connector of this VCR.
get to the output/input set screen Press m. Move the highlight bar to
OUTPUT/INPUT SET using the A and B buttons and press
O
K
3
/
(or E).
select mode Move the highlight bar to L-1
OUTPUT
or L-1 INPUT using the A and B
buttons. Press
OK
3
/
(or E) to select the
desired mode:
FOR L-1 OUTPUT
VIDEO : If a connected device’s input is
compatible only with regular
video signals, set to
VIDEO.
S-VIDEO : If a connected device’s input is
compatible with Y/C signals, set to
S-VIDEO. This setting will let you take advantage of higher-quality
S-VHS pictures. (For connection, be sure to use a 21-pin SCART
cable that is compatible with the Y/C signal.)
FOR L-1 INPUT
VIDEO : If a connected device’s output is compatible only with regular video
signals, set to
VIDEO.
S-VIDEO : If a connected device’s output is compatible with Y/C signals, set to
S-VIDEO. This setting will let you take advantage of higher-quality
S-VHS pictures. (For connection, be sure to use a 21-pin SCART
cable that is compatible with the Y/C signal.)
return to normal screen Press m.
NOTES:
•If
L-1 OUTPUT is set to S-VIDEO, it is impossible to set L-1 INPUT to S-VIDEO.
[1] a k
[MENU]: EXIT
OUTPUT/INPUT SET
L-1 OUTPUT VIDEO
L-1 INPUT VIDEO
L-2 SELECT A/V
L-2 INPUT VIDEO
F
HR-S8965EK-EN/p31-54 4/19/03, 01:16 PM50