Filter
Top Products
advanced features52
Editing Using Another VCR
connect up Connect the player’s 21-pin SCART connector to the recorder’s
21-pin SCART connector as illustrated.
A When using your VCR as the player ...
... connect its
AV1 (L-1) IN/OUT connector to another VCR.
B When using your VCR as the recorder ...
... connect its
AV2 (L-2) IN/DECODER or AV1 (L-1) IN/OUT connector to another
VCR.
If another VCR is compatible with Y/C signal ...
... When using your VCR as the player, set L-1 OUTPUT to S-VIDEO (੬ pg.48).
... When using your VCR as the recorder, set L-2 INPUT to S-VIDEO (੬ pg.49).
set vcr’s input mode The recording VCR mode must be set to AUX. If this
VCR is the recorder, press
AUX and/or PR to select L-1 (if you’ve used the AV2
(L-2) IN/DECODER
connector) or L-2 (if you’ve used the AV1 (L-1) IN/OUT
connector). If this VCR is the player, set O.S.D. to OFF. (੬ pg.55)
• When using the
AV2 (L-2) IN/DECODER connector, set L-2 SELECT to the
appropriate mode. (੬ pg.51)
set edit mode See Picture Control on page33.
start source vcr Engage its PLAY mode.
start recording vcr Engage its RECORD mode.
NOTES:
• All necessary cables can be obtained from your dealer.
• For Y/C signal input/output, be sure to use a 21-pin SCART cable that is
compatible with the Y/C signal.
• When you set
PICTURE CONTROL to EDIT to dub tapes (੬ pg.33), be sure to
select
AUTO (or NORM when B.E.S.T. is set to OFF) after you finish dubbing the
tapes.
• If you are using another VCR with S-Video and Audio input/output
connectors, you can connect those connectors to this VCR’s S-VIDEO IN/S
OUT and AUDIO IN/OUT connectors.
When using your VCR as the player ...
... connect its rear panel S OUT and AUDIO OUT connectors to the recording
VCR’s S-Video and Audio input connectors.
When using your VCR as the recorder ...
... connect its front panel S-VIDEO and AUDIO input connectors to the
player’s S-Video and Audio output connectors. Then, set the VCR’s input
mode to S-1.
HR-S8965EK-EN/p31-54 4/19/03, 01:16 PM52