Filter
Top Products
advanced features56
set input mode Press AUX and/or PR so that F-1 appears in place of a channel number.
locate start point Press . to start playback of the tape in your VCR, and press | when you
find the point where you find the point where you want to start dubbing.
engage audio dubbing Press A. DUB.
• Your VCR enters the Audio Dubbing Pause mode, (‘U’ blinks, ‘d’and ‘
’ light up on the
display panel.)
• To perform Audio Dubbing with audio mixing, press AUDIO to select ‘
+
(L+R)’ at this
point.
• Audio Dubbing with audio mixing is not possible if you’re using a monaural audio component,
or if you don’t have an audio mixer.
start dubbing Engage the audio component’s Play mode, then press to start the tape in your
VCR. Audio Dubbing begins at this point.
• ‘U’ blinks and ‘d’ is displayed on the display panel.
• To stop dubbing temporarily, press |. Press . to resume dubbing.
end audio dubbing Press S to stop the tape in your VCR, and engage the audio component’s
Stop mode.
NOTES
• When monitoring the sound during Audio Dubbing, the normal soundtrack is automatically
selected. If you wish to hear the mixed sound (Hi-Fi + Normal soundtracks), press AUDIO on
the Remote Control to select ‘
+
(L+R) + NORM’ (੬ pg. 37).
• Audio Dubbing stops automatically when the counter reaches ‘0:00:00’, and the VCR enters the
Play mode. Check the counter reading before dubbing.
• Audio Dubbing is also possible using the rear panel AV1 (L-1) IN/OUT or AV2 (L-2) IN/
DECODER connector. When using these connectors, make sure to select the correct input mode
in the procedures above.
• Audio Dubbing cannot be performed on a cassette that has had its record safety tab removed.
• When playing back an audio-dubbed tape, preaa AUDIO on the Remote Control to select the
soundtrack you wish to hear (੬ pg. 37).
HR-S8965EK-EN/p55-63 4/19/03, 01:04 PM56