JVC HR-S8965EK VCR User Manual


 
advanced features 51
[1] a k
[MENU]: EXIT
OUTPUT/INPUT SET
L-1 OUTPUT VIDEO
L-1 INPUT VIDEO
L-2 SELECT A/V
L-2 INPUT VIDEO
F
L-2 SELECT/INPUT Setting
The AV2 (L-2) IN/DECODER connector accepts either a composite signal (regular
video signal) or a Y/C signal (a signal in which the luminance and chrominance
signals are separated). Set
L-2 SELECT to the appropriate mode depending on the
type of unit connected to the rear panel A
V2 (L-2) IN/DECODER connector of this
VCR. Set
L-2 INPUT to the appropriate mode depending on the output signals of
the connected unit.
get to the output/input set screen Press m. Move the highlight bar to
OUTPUT/INPUT SET using the A and B buttons and press
O
K
3
/
(or E).
select mode Move the highlight bar to L-2
SELECT
or L-2 INPUT using the A and B
buttons. Press
OK
3
/
(or E) to select the
desired mode:
FOR L-2 SELECT
A/V : To use this VCR as the re-
corder with the player con-
nected to the A
V2 (L-2) IN/
DECODER
connector, or to use
the satellite receiver connected
to the A
V2 (L-2) IN/DECODER
connector.
SAT : To view a satellite programme with the TV set while the VCR is
turned off. ( pg. 48)
FOR L-2 INPUT
VIDEO : If a connected device’s output is compatible only with regular video
signals, set to
VIDEO.
S-VIDEO : If a connected device’s output is compatible with Y/C signals, set to
S-VIDEO. This setting will let you take advantage of higher-quality
S-VHS pictures. (For connection, be sure to use a 21-pin SCART
cable that is compatible with the Y/C signal.)
return to normal screen Press m.
NOTES:
If you have a satellite receiver or a decoder connected to the A
V2 (L-2) IN/
DECODER
connector, be sure to set L-2 SELECT back to appropriate mode after
editing.
If you’re not connecting a satellite receiver or a decoder to the A
V2 (L-2) IN/
DECODER
connector, leave L-2 SELECT set to A/V.
The default setting is
A/V; if the VCR’s memory backup has expired due to a
power cut or because the AC was removed from the VCR,
A/V will be auto-
matically selected when the power is restored to the VCR. If you are using a
satellite receiver or a decoder, be sure to set
L-2 SELECT back to appropriate
mode.
When
L-2 SELECT is set to SAT, ‘SAT’ appears on TV screen instead of ‘L-2’, or
on the display panel instead of ‘L2’.
HR-S8965EK-EN/p31-54 4/19/03, 01:16 PM51