JVC LT-32DG8BJ Flat Panel Television User Manual


 
11
12
English
First Time Installation > Language Setting
Step 1: Please choose language
Language
First Time Installation > Country Setting
Step 2: Please choose country
Country
United Kingdo
m
First Time Installation > Service Scan
Step 3: Please press OK
Scan Automatic
Start Channel
_ _
Stop Channel
_ _
Mode Add
Start Scan
Service
First Time Installation > Service Scan
Step 3: Please press OK
Scan Automatic
Start Channel
_ _
Stop Channel
_ _
Mode
Add
Start Scan
Service
BBC ONE
UHF33 : 3 Services found
BBC THREE
BBC TWO
Stop
Channel
_ _
Mode Add
Start Scan
Teema
Teema
Teema
Yes No
Scan completed! Store services?
No services found!
OK
Start Channel
_
_
Stop Channel
_
_
Mode Ad
d
Start Scan
On
Of
f
Antenna Powe
r
IMPORTANT! PREPARE USE
SETTINGS
TROUBLE?
Initial settings
Register digital / analogue channels on TV. These channels can be edited later.
(In this manual, digital terrestrial broadcasting is indicated as digital channels,
analogue terrestrial broadcasting and analogue cable TV as analogue channels.)
BACK
TV/DTV
If the “JVC” logo does not appear or if you
wish to make changes later
Digital channel settings : “Configuration” (P. 39)
“Installation” (P. 43)
Analogue channel settings : “SET UP” (P. 34)
Set digital channels
Confirm “English” is set
Confirm “United Kingdom” is set
Scan digital channels
Register digital channels
1
2
4
5
What is “T-V LINK”?
Connecting the TV to a “T-V LINK”
compatible device allows :
Analogue channels to be instantly
registered on the device.
The “DIRECT REC” function to be
used.
“Technical information” (P. 54)
“T-V LINK” variations
“T-V LINK” (JVC) “Q-LINK” (Panasonic)
“Megalogic” (Grundig) “Data Logic” (Metz)
“SMARTLINK” (Sony) “Easy Link” (Philips)
If digital channels are not found, the following message will appear.
After completing following steps, read “When the TV cannot find the digital
channels” (P. 14) and try scanning digital channels again
Language for on-screen
displays when watching digital
channel including the DTV
menu.
2 next
1 select
!
(Next page)
3
Set the aerial power supply
Only when using an aerial which
needs external power, select “On”.
“Power supply for the indoor
aerial” (P. 55)
To the previous screen
Exit
Begin
The remote control
doesn’t work
Confirm the mode is set to
“TV”.
1
2
Shown only when powering on for the first time.
The power button on the unit can also be used.
This TV can only receive
British digital channels.
11-12 19/03/2007 08:48:33