Filter
Top Products
13
14
21
AUTO PROGRAM
0%
CH
EDIT
01
AV
PR
02
03
04
05
06
07
08
09
ID CH
_ _ _ _ _
CH
21
CH
22
CH
23
CH
24
CH
25
CH
26
CH
27
CH
28
BBC1
BBC2
ITV
CH4
CH5
_ _ _ _
_
DOWNLOAD TV RECORDING DEVICE
T-V LINK
LANGUAGE
COUNTRY
IMPORTANT! PREPARE USE
SETTINGS
TROUBLE?
Initial settings (continued)
4
Set analogue channels
Initial setting is complete
Edit digital channels Editing digital channels (P. 45)
If digital channel reception is poor When the digital channel reception is poor (P. 14)
If analogue channel reception is poor Troubleshooting (P. 49)
Some digital channels cannot be watched on this TV. (P.55)
5
Register analogue channels
Check what was registered
Edit analogue channels
@ in “Editing analogue
channels” (P. 47)
When not using
“T-V LINK”
When using “T-V LINK”
If “FEATURE NOT
AVAILABLE” appears :
Is a “T-V LINK” compatible
device connected to “EXT-2”?
Is the device turned on?
Set T-V LINK
Confirm
Confirm the language
select
3
When not using analogue channels
When using analogue channels (or cable TV)
When change a language
1
2
3
select
When change a country
When the TV cannot find the digital channels
Is the TV connected correctly to the aerial?
Change the direction of the indoor aerial.
Is there a digital channels transmission tower nearby?
Turn “ATTENUATOR” to “ON” (P. 34), since the radio waves are too strong.
Check the following points
Register digital channels again “Service Scan” (P. 43)
If you still cannot watch digital channels after following the steps above, there may be a problem
with your aerial or its cable. Or, the signal may be too weak. Consult your retailer
When the digital channel reception is poor
The “Missing or weak signal” message appears.
Check digital channels signal Signal Check (P. 43)
If you still cannot watch digital channels after following the steps above, there may be a problem
with your aerial or its cable. Or, the signal may be too weak. Consult your retailer
Is the TV connected correctly to the aerial?
Change the direction of the indoor aerial.
Is there a digital channels transmission tower nearby?
Turn “ATTENUATOR” to “ON” (P. 34), since the radio waves are too strong.
Check the following points
Language for
on-screen analogue
channel displays and
menus (excluding the
DTV menu)
@
⁄
(blue)
When “RF Attenuator” setting screen is displayed
Set “ATTENUATOR” (P. 34) from this setting screen.
To set the “ATTENUATOR” on select “On”, to set it off select “Off”
This setting screen will appear during the “Factory Settings” (P. 43) with “ATTENUATOR” set to “ON”.
13-14 19/03/2007 08:48:35