Filter
Top Products
40 EN
Master Page: Left
The audio track of a tape recorded in DV format can
be customised only when recorded in the 12-bit and
SP modes. (੬ pg. 27)
1 Play back the tape to locate the point where
editing will start, then press PAUSE (9).
2 While holding A. DUB (D) on the remote
control, press PAUSE (9). The “9D” and “MIC”
indicators appear.
3 Press PLAY (U), then begin “narrating”. Speak
into the microphone.
● To pause dubbing, press PAUSE (9).
4 To end Audio Dubbing, press PAUSE (9), then
STOP (8).
To hear the dubbed sound during playback…
Set “DV NARR.” to “ON” or “MIX”. (੬ pg. 26, 27)
NOTES:
● When editing onto a tape that was recorded at
12-bit, the old and new soundtracks are recorded
separately.
● If you dub onto a blank space on the tape, the
sound may be disrupted. Make sure you only edit
recorded areas.
● If feedback or howling occurs during TV playback,
move the microphone away from the TV, or turn
down the TV’s volume.
● If you change from 12-bit to 16-bit in mid-
recording and then use the tape for Audio
Dubbing, it is not effective from the point where
16-bit recording began.
● During Audio Dubbing, when the tape moves to
scenes recorded in the LP mode, scenes recorded
in 16-bit audio or a blank portion, Audio Dubbing
stops.
● To perform Audio Dubbing while watching on the
television, make connections. (੬ pg. 18)
● To perform Audio Dubbing with a video unit
connected to the player’s S, AUDIO(L/R), VIDEO
connector, first set “S/AV INPUT” to “ON” in
VIDEO Menu. (੬ pg. 26, 27)
The “AUX” indication appears instead of “MIC”.
However, you cannot hear the sound from the
connected device through the headphones.
Audio Dubbing (DV mode only)
Speaker
Microphone
Open the cover.
Audio
cable
(provided)
USING THE REMOTE CONTROL UNIT (cont.)
CU-VH1E.book Page 40 Friday, March 26, 2004 1:55 PM