JVC LYT1300-001A DVD Player User Manual


 
52 EN
Master Page: Left
5. Dirty heads can cause the following problems:
No picture during playback.
Blocks of noise appear during playback.
During playback, the Head Clog Warning
indicator “” appears.
In such cases, use an optional cleaning cassette.
Insert it and play back. If the cassette is used more
than once consecutively, damage to the video heads
may result. After the player plays back for about 20
seconds, it stops automatically. Also refer to the
cleaning cassettes instructions.
If, after using the cleaning cassette, the problems still
exist, consult your nearest JVC dealer.
Mechanical moving parts used to move the video
heads and video tape tend to become dirty and
worn out over time. In order to maintain a clear
picture at all times, periodic check-ups are
recommended after using the unit for about 1,000
hours. For periodic check-ups please consult your
nearest JVC dealer.
Serious malfunctioning
About moisture condensation...
You have observed that pouring a cold liquid
into a glass will cause drops of water to form on
the glass outer surface. This same phenomenon
occurs on the head drum of a player when it is
moved from a cool place to a warm place, after
heating a cold room, under extremely humid
conditions or in a place directly subjected to the
cool air from an air conditioner.
Moisture on the head drum can cause severe
damage to the video tape, and can lead to
internal damage to the player itself.
If malfunctioning occurs, stop using the unit
immediately and consult your local JVC dealer.
The player is a microcomputer-controlled device.
External noise and interference (from a TV, a
radio, etc.) might prevent it from functioning
properly. In such cases, first disconnect its power
supply unit (battery pack, AC Power Adapter/
Charger, etc.) and wait a few minutes and then re-
connect it and proceed as usual from the
beginning.
CAUTIONS (cont.)
CU-VH1E.book Page 52 Friday, March 26, 2004 1:55 PM