Filter
Top Products
21
GENLOCK MENU
MENU OPERATION
This menu is used to set the camera cable length to the length actually used.
(
REF.
: “Adjustments for Genlock Operation” on page 13.)
128
0°
128
–
No. Item Function, Operation
Available Settings
Initial Setting
1A
1B
1C
1Z
H PHASE
SC COARSE
SC FINE
BACK
Adjustment of the Horizontal sync phase of genlocking.
Coarse adjustment of the color phase of genlocking.
Use a vectorscope, etc.
Fine adjustment of the color phase, which should be performed
after completing the SC COARSE adjustment.
If the subcarrier cannot be adjusted with SC FINE, restart the
adjustment from SC COARSE.
Return to the previous display.
0 to 255
0°, 90°,
180°, 270°
0 to 255
–
CABLE MENU
This menu sets the camera cable length according to the actual length used.
(
REF.
: “Camera Cable Length Setup” on page 12.)
20M
NORMAL
NORMAL
–
No. Item Function, Operation
Available Settings
Initial Setting
2A
2B
2C
2Z
LENGTH
Y CABLE EQ
C CABLE EQ
BACK
Set according to the total length of the camera cables in use.
Fine adjustment of the luminance signal.
Fine adjustment of the chrominace component.
Return to the previous display.
5M, 20M,
50M, 100M
-128 to
NORMAL to
127
-128 to
NORMAL to
127
–
This adjustment causes the phase to be altered. Be sure to
adjust SC FINE after this adjustment.
NOTE