Filter
Top Products
37
VTR MODE 1
(SHARPNESS) NORMAL
(AUTO REC) ON
(REC CHECK) MANUAL
(TAPE END MODE) REPEAT
(INDEX SEARCH) OFF
(CAMERA SW) OFF
(TAPE END BUZZER) ON
(WARNING BUZZER) OFF
PRESS (SHIFT, SET)
PRESS (MENU) TO END
VTR MODE 1
(SHARPNESS) NORMAL
(AUTO REC) ON
(REC CHECK) MANUAL
(TAPE END MODE) REPEAT
(INDEX SEARCH) OFF
(CAMERA SW) OFF
(TAPE END BUZZER) OFF
(WARNING BUZZER) OFF
PRESS (SHIFT, SET)
PRESS (MENU) TO END
7-9 How to Restore Recording After Power Failure
7 RECORDING
If a power failure occurs during recording, recording will
restart in the same mode as soon as power is restored.
To use this function, set the function menu switch <AUTO
REC> to ON.
* If this function menu switch is set to ON and power is
turned off and on again in the Stop mode, the VCR
enters the Record mode automatically. Be careful.
7-10 External Timer Recording
External timer recording can be performed by connecting the SR-9168U to an external timer.
1 Check that a cassette is loaded in the VCR.
* If the cassette’s safety tab has been removed,
recording will not take place.
* This function does not work when the Timer Record
mode is engaged.
2 Set the function menu switch <AUTO REC> to ON.
Power is supplied from the external timer at the
specified time and recording starts.
When set to ON, a buzzer sounds when the tape ends
during recording. To set the buzzer sound on, set the
function menu switch <TAPE END BUZZER> to ON.
5 Set timing for the buzzer with <REC REMAIN> or
<COUNT END>. For details, refer to "Contents of the
Function Menu Switches" on page 21.
When the tape reaches the specified position, the
following signals are output in addition to the tape end
buzzer sound.
• Tape end signal from the rear panel's [TAPE END
OUT] terminal
• Series recording signal from the rear panel's [SERIES
OUT] terminal during series recording
• “End” indication in the counter display
5 To stop the buzzer sound, you can set the <TAPE END
BUZZER> function menu switch to OFF, turn off the
power, or press another operation button.
5 During repeat recording and AUTO REW, the buzzer
sounds for about 2 seconds.
Set to
ON
TAPE END
BUZZER
AUTO REC
Set to
ON
VTR mode 1 setting screen
VTR mode 1 setting screen
7-11 Tape End Buzzer