Filter
Top Products
12
If you do not know the frequencies used by your
cable network operator, use the
button to select
the lowest frequency permitted by the receiver for
starting the search (keep the
button pressed
until the
button is no longer shown in the start
frequency line).
Press the
buttons to access the next line.
Press the
button to select the highest permitted
by the receiver for ending the search (keep the
button pressed until the
button is no longer
shown in the end frequency line).
FIRST INSTALLATION
Use the
buttons to select whether the network search should be “On” or “Off”. If the network search
is set to “On” you will be shown the “Manual Search” in the next display. You should use this if your cable
network operator has advised you of the frequency that can be searched.
If you do not know the frequency or frequencies to be searched, set the network search to “Off”. You will
then be shown the “Automatic Search”. Press the
buttons to access the line “Sorting”. Use the
buttons to specify how the channels should be sorted in the channel list. You have the following options:
“A to Z”, “Z to A”, by “Provider”, “Service ID” or “None”.
Press the
buttons to access the next line. Press the
button to go to the next menu:
Network search “Off” Network search “On”
Note: The frequencies, symbol rates and modulation settings used, and the channels available,
may be different for different cable network operators. So as to keep the search time as short
as possible, you can ask your cable network provider in advance for information on which
channels are transmitted on which frequencies with which symbol rates and with which sort of
modulation, and then set up the search accordingly.
If you know your cable network provider’s
frequency, use the
buttons to set the
desired start frequency for the search.
Press the
buttons to access the next line.
If necessary you can input the frequency again at
this point, using the numeric pad buttons.
Press the
buttons to access the next line.
If necessary you can input the symbol rate again
at this point, using the numeric pad buttons on the
remote control.
Press the
buttons to access the next line.
If necessary you can set the type of modulation at
this point, using the
buttons.