Filter
Top Products
7
CONNECTION AND SET-UP
The following section is intended specifi cally for specialist dealers. You need not refer to this section
unless you are carrying out the installation yourself. The “Connection Example” section provides a
sample confi guration.
Do not connect the receiver to the mains until all installation work has been properly carried out. Refer also
to the information in the “Safety Instructions” section.
CONNECTING THE RECEIVER
Connect the RF input of the receiver to the antenna socket.
Use a coaxial cable with a standard IEC connector. If the IEC connector is not yet fi tted to the cable, strip the
insulation from the cable as shown in the following illustration and carefully fi t the connector on to the end of
the cable so that it is securely fi tted.
RF(HF) CONNECTION
TV CONNECTION
Connect the cable receiver (TV Scart socket) to the TV set using a Scart cable. If your TV has a stereo
feature, you can receive the sound in stereo via the Scart connection. Connect the cable receiver to the
video/DVD recorder using a Scart cable.
INSERTING BATTERIES INTO THE REMOTE CONTROL
Remove the cover on the rear of the remote control.
Insert the two batteries supplied into the remote control. Ensure correct polarity of the batteries; the + and
– markings are indicated inside the battery compartment. Slide the cover back into the housing until it locks
into place.
When fi tting the connector, make sure that no wires from the braiding are touching the
inner conductor, otherwise a short circuit will occur.
The quality of the reception signal depends on this connection!
Lengthwise slits (3×) Bend back Screw together