Filter
Top Products
34
MANUAL SEARCH
SEARCH FOR CHANNELS
Use the
buttons to select the transmission channel (with transmission frequencies) that is to be
searched. Press the
buttons to access the next line. If the displayed transmission frequency does not
match your data, you can use the numeric pad to enter it here manually. Press the
buttons to access
the next line. If the displayed symbol rate does not match your data, you can also use the numeric pad to
enter it here manually. Press the
buttons to access the next line. If the displayed modulation does not
match your data, you can use the
buttons to enter it here manually.
Press the
buttons to access the next line. If the displayed modulation does not match your data, you
can use the
buttons to enter it here manually.
Press the
buttons to access the “Network search” line. Use the
buttons to select whether the
network search should be “On” or “Off”. If the network search is “On”, the networking between individual
cable transponders is used to fi nd new cable transponders that have not yet been saved. These too are then
searched for new channels.
Press the
buttons to access the next line. Use the
buttons to perform the settings for the
channels to search for. You can select from “All”, “Only encrypted” and “Only free to air”.
Press the
buttons to access the next line. Pressing the
button starts the “Search for Channels”.
The rest of the procedure (and displays) is identical to the automatic search.
So as to perform a
targeted search for
specifi c channels,
the data must appear
in the four lines frequency to
modulation.